Liebert Network Router micro smart switch Manuel d'utilisateur télécharger pdf (Page 5)

Installation

Place rear rail [R] over the studs in the front rail [F]. Tighten nuts finger tight.

The mounting tab [T] will be facing out, so the holes align with the rack sides.

Adjust length of rail assembly to fit inside rack. Tighten either the wing nuts or

hex nuts.

Insert cage nut (one on each side) in rack. Set hooks at rear of rail over holes in

ack. Use screw [2] (one on each side) to attach rails to rear of rack through cage

nut. Use screw [2] (two on each side) to attach rails to front of rack.

Use screws [1] (two on each side) to attach brackets to side of unit. Slide unit

into rails and secure by using screws [2] (one on each side) to attach the unit.

FRONT

OUT SIDE

DISCONTINUED

PROD U C T

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Liebert Network Router micro smart switch Manuel d'utilisateur Page 5