Liebert Power Strips Manuel d'utilisateur télécharger pdf (Page 5)

SET THE IP ADDRESS

1. Select “1” to set the IP Address for Module 1. Enter an IP address (below). The address must be

unique on your system (obtain this from your network administrator).

2. Press Enter to return to the Network Port Configuration menu.

3. Choose “2” to set the Subnet Mask for your system (obtain this from your network administrator).

SET THE GATEWAY ADDRESS

1. Return to the Network Port Configuration menu and choose “3” to set the Gateway Address (the IP

address of your network router). Follow the prompts to exit HyperTerminal and save your changes.

2. Verify that your settings are correct and were saved by using a command prompt to ping the

MP-C/MP-S unit: Start>Run>CMD.

3. At the command prompt enter:

ping [IP address]

4. Press “Enter.”

Enter IP address

1 2 3 4 5 6

Pas de commentaire

Liebert Power Strips Manuel d'utilisateur Page 5